Chapter 1 Using the Operator Panel
1-57
Follow the procedure given below to change the recovery
time for Auto Continue.
Press the MENU key.
Press the or key repeatedly until Others > ap-
pears.
Press the key.
Press the or key repeatedly until >Auto
Continue Mode > appears.
Press the key and display >>Auto Continue
Timer.
Press the ENTER key. A blinking cursor (_) appears.
Press the or key to increase or decrease the val-
ue of the figure where the cursor is blinking and set
the desired time. The time must be set between 000
and 495 seconds, in 5-second increments. If set to
000, printing will be continued immediately without
allowing any time interval. You can use the and
keys to move the cursor right and left.
Display the desired time and press the ENTER key.
Press the MENU key. The message display returns to
Ready.
Setting the Auto Continue Recovery Time
Others >
>Auto Continue >
Mode On
>>Auto Continue
Timer 030
Sec.
1
2
3
4
5
6
7
8
9
To Next Page
Loading...
