Kyocera FS-6020 - Resetting the Type Adjust; Adjusting the Print Density

Chapter 1 Using the Operator Panel
1-21
Resetting the Type Adjust
You can reset the custom settings (Custom1 to 8) that are set
as described in
Customizing the Paper Type on page 1-19 .
Press the MENU key.
Press the or key repeatedly until Paper
Handling > appears.
Press the key.
Press the or key repeatedly until >Reset
Type Adjust appears.
Press the ENTER key. A question mark (?) appears.
Press the ENTER key. All the customized paper
weight and duplex path settings will be reset to the
default. The message display returns to Ready.
The print density can be adjusted in five steps: from 01 (light)
to 05 (dark). The default setting is 03.
Press the MENU key.
Press the or
key repeatedly until Paper
Handling > appears.
Press the key.
Press the or key repeatedly until >Type
Adjust > appears.
Press the
key.
Press the or key repeatedly until >>Print
Density appears.
Press the ENTER key. A blinking question mark (?)
appears.
Select the print density from five steps from 01
(light) to 05 (dark) using the or key.
Press the ENTER key.
Press the MENU key. The message display returns to
Ready.
This finishes the custom paper type settings.
Paper Handling >
>Reset Type
Adjust
>Reset Type
Adjust ?
1
2
3
4
5
6
Adjusting the Print Density
Paper Handling >
>Type Adjust >
Custom 1
>>Print Density
03
>>Print Density
? 03
1
2
3
4
5
6
7
8
9
10