Kyocera FS-6020 - Selecting the Printing Orientation; Setting the KIR Mode

Chapter 1 Using the Operator Panel
1-32
You can select the portrait or landscape page orientation. The
page orientation can be set whenever the message display in-
dicates Ready.
Press the MENU key.
Press the or key repeatedly until Page Set >
appears.
Press the key.
Press the or key repeatedly until
>Orientation appears.
Press the ENTER key. A blinking question mark (?)
appears.
Select Portrait or Landscape using the or
key.
Press the ENTER key.
Press the MENU key. The message display returns to
Ready.
This printer incorporates the KIR (Kyocera Image Refine-
ment) smoothing function. KIR users the software to enhance
resolution, resulting in high quality printing at resolution of
600 dpi and 300 dpi. The default is On. KIR has no effect on
the printing speed.
Set the print density to 03 when setting the KIR mode. For de-
tails on the print density, see Verifying the Total Printed Pages
on page 1-52. You can monitor the KIR test pattern, the last line
on a status page, to make the optimum KIR mode setting.
Look at the check line, the last line on a status page, to make
the optimum KIR mode setting.
Selecting the Printing Orientation
Page Set >
>Orientation
Portrait
>Orientation
? Portrait
Portrait
Landscape
A
A
BC
BC
1
2
3
4
5
6
7
8
Setting the KIR Mode
NOTE
With KIR Off With KIR On (default)
KIR Test pattern ON
Memory
InstalledOptions
NetworkStatus
Emulation
TonerGauge
0
100
Interfaces
HardwareInformation
PageInformation
ErrorLog
STATUSPAGE
FS-6020 Page Printer
Firmware Version: Released:
Status Page
KIR Test Pattern
Optimized stripes
The current KIR setting is optimal.
Dark vertical stripes
Set the KIR mode to Off. Try printing
the status page again. If you still get
dark vertical stripes, adjust the print
density control to a lighter setting.
White vertical stripes
Set the KIR mode to On. Try printing
the status page again. If you still get
white vertical stripes, adjust the print
density control to a darker setting.