Chapter 1 Using the Operator Panel
1-29
Setting the Character Pitch for Courier/Letter
Gothic
You can set the character pitch for fixed-pitch fonts when the
default font is Courier or Letter Gothic.
Press the MENU key.
Press the or key repeatedly until Font > ap-
pears.
Press the key.
Check that Internal is displayed and press the
key.
Press the or key repeatedly until >>Pitch ap-
pears.
Press the ENTER key. A blinking cursor ( _ ) ap-
pears.
Press the or key to increase or decrease the val-
ue of the figure where the cursor is blinking. The
character pitch can be set between 0.44 and 99.99
characters per inch, in 0.01 character-per-inch incre-
ments. You can use the and keys to move the
cursor right and left.
When the desired size is displayed, press the ENTER
key.
Press the MENU key. The message display returns to
Ready.
You can change the character code set. Available character
code sets vary depending on the current font. (The default is
IBM PC-8.)
Press the MENU key.
Press the or key repeatedly until Font > ap-
pears.
Press the key.
Press the or key repeatedly until >Code Set
appears.
Press the ENTER key. A blinking question mark (?)
appears.
Press the or key until the desired character
code set appears.
Press the ENTER key.
Press the MENU key. The message display returns to
Ready.
Font >
>Font Select >
Internal
>
>Pitch
10.00 cpi
>
>Pitch
10
.00 cpi
1
2
3
4
5
6
7
8
9
Setting the Code Set
Font >
>Code Set
IBM PC-8
>Code Set
?IBM PC-8
1
2
3
4
5
6
7
8
To Next Page
Loading...
