Chapter 1 Using the Operator Panel
1-46
The printer supports three types of storage device; memory
card, option hard disk, and RAM disk. The memory card and
option hard disk are installed into the dedicated slots of the
printer. The RAM disk is an allocated part of the printer’s
memory.
The basic operations of each storage device are the same.
This section mainly explains the operation of the memory
card.
The printer is equipped with a slot for a memory card. By in-
serting a memory card into the printer, the following opera-
tions become available.
•Reading Font Data
•Reading Data
•Writing Data
•Deleting Data
•Formatting Memory Card
•Printing a List of Data Names
For details about the handling of the memory card, see
Memory Card on page 6-6
.
Reading Font Data
In case of a memory card if a memory with the font data card
is already inserted into the slot when the printer is turned on,
the fonts are automatically read into the printer. To read fonts
into the printer from a memory card, proceed as follows.
Press the MENU key.
Press the or key repeatedly until Memory
Card > appears.
Press the key.
Press the or key repeatedly until >Read
Fonts appears.
Press the ENTER key. A question mark (?) appears.
Press the ENTER key. Processing appears and the
reading of data from the memory card starts. When
completed, Processing disappears.
Press the MENU key. The message display returns to
Ready.
Reading Data
Data stored on a memory card can be read. To read data on a
memory card, proceed as follows.
Press the MENU key.
Press the or key repeatedly until Memory
Card > appears.
Press the key.
Press the or key repeatedly until >Read Data
appears. The data name also appears. These are the
partition names the printer automatically assigns.
Press the ENTER key. A blinking question mark (?)
appears before the data name.
Press the or key to display the desired data
name.
Press the ENTER key. Processing appears and the
reading of data from the memory card starts.
Operating the Storage Device
Using the Memory Card
Memory Card >
>Read Fonts
>Read Fonts ?
1
2
3
4
5
>Read Fonts
Processing
Memory Card >
>Read Data
DataS001
>Read Data
?DataS001
6
7
1
2
3
4
5
6
7
To Next Page
Loading...
