Chapter 1 Using the Operator Panel
1-45
Press the key. Each time the or key is
pressed, the display changes as shown below.
.
The following example explains how to activate
TCP/IP protocol to connect the printer in the net-
work. You can select Netware or EtherTalk in a
similar manner.
If TCP/IP is currently Off is displayed, select On
using the or key. Press the ENTER key again.
Press the key. Each time the or key is
pressed, the item changes as shown below.
Display the item to be set and press the ENTER key.
For DHCP, a question mark (?) appears. For IP Ad-
dress, Subnet Mask, and Gateway, the cursor (
)
blinks.
For DHCP , select On or Off using the or key.
For IP Address, Subnet Mask, and Gateway ad-
dresses, press the or key to change the number
(000 to 255) where the cursor is blinking. You can
use the and key to move the cursor right and
left.
To obtain these addresses, consult your network
administrator.
Press the ENTER key.
Press the
MENU key. The message display returns
to
Ready.
>TCP/IP >
On
6
>NetWare >
On
>TCP/IP >
On
>EtherTalk
Off
>Opt. StatusPage
Off
Set this item to On when
you connect to a network
using NetWare. In the sub-
menu (>), frame mode can
be selected from Auto,
Ethernet II , 802.2, and
802.3 SNAP
Set this item to On when
you connect to a Windows
network using TCP/IP.
The sub-menu (>) has
items including DHCP, IP
address, subnet mask
address, and gateway
address. For details on IP
address, see the following
step 8 and subsequent
steps.
When the item is set to On,
the printer also prints out
a network status page
when it prints the printer
status page. See
Printing
the Option Network
Status Page on page 1-12
.
Range
EtherTalk must be
activated (On) for
AppleTalk networking
with Macintosh
7
>TCP/IP
? On
>TCP/IP >
On
8
>>DHCP
Off
>>IP Address
000.000.000.000
>>Subnet Mask
000.000.000.000
>>Gateway
000.000.000.000
9
10
11
12
To Next Page
Loading...
