Chapter 1 Using the Operator Panel
1-20
Setting the Paper Weight
You can set the paper thickness for your customized paper
type.
The default setting is Normal for each customized paper type
(Custom 1 to 8). The printer is factory-set so as to provide the
optimal printing functions/quality in this setting, which you need
not change for ordinary custom paper.
Display the custom paper type (see
Customizing the
Paper Type on page 1-19
) and press the key.
Press the or key repeatedly until >>Paper
Weight appears.
Press the ENTER key. A blinking question mark (?)
appears.
Press the or key to display the desired paper
thickness. The display changes as shown below.
Normal (default)
Heavy (Thick)
Extra Heavy
Light (Thin)
When the desired paper thickness displayed, press
the ENTER key.
Press the MENU key. The message display returns to
Ready.
If the paper type is set to Custom and the option du-
plexer is installed on the printer, duplex printing
can be enabled and disabled. See the following sec-
tion
Setting the Duplex Path
.
Setting the Duplex Path
To use this function, the duplexer must be installed on the print-
er.
If the paper type is set to Custom, you can set whether or not
to enable duplex printing as follows. The default setting is
Enable.
Display the custom paper type (see
Customizing the
Paper Type on page 1-19
) and press the key.
Press the or key repeatedly until >>Duplex
Path appears.
Press the ENTER key. A blinking question mark (?)
appears.
Select Enable or Disable using the or key.
Press the ENTER key.
Press the MENU key. The message display returns to
Ready.
NOTE
>>Paper Weight
Normal
>>Paper Weight
? Normal
1
2
3
4
5
6
NOTE
>>Duplex Path
Enable
>>Duplex Path
? Enable
1
2
3
4
5
6
To Next Page
Loading...
