Kyocera FS-6020 - Setting the Default Font; Selecting the Default Font

Chapter 1 Using the Operator Panel
1-27
Press the ENTER key. A blinking question mark (?)
appears.
Select KPDL or KPDL (AUTO) using the or key.
Press the ENTER key.
Press the key. The message display changes to
that shown below. If >Alt. Emulation is displayed
when the KPDL (AUTO) emulation is selected, press
the or key to change it.
Press the ENTER key. A blinking question mark (?)
appears.
Select On using the or key.
Press the ENTER key.
Press the MENU key. The message display returns to
Ready.
You can select the default font for the current interface. In ad-
dition to the internal fonts, all fonts that are downloaded to
the printer memory, or fonts stored on a memory card or op-
tion hard disk can be selected as the default font.
You can also set the type and pitch for Courier and Letter
Gothic.
Selecting the Default Font
Press the MENU key.
Press the or key repeatedly until Font > ap-
pears.
Press the key to select an internal font, press the
or key repeatedly until Internal appears.
To select an option font, press the ENTER key while
>Font Select > is displayed. Press the or
key repeatedly until the message display indicates
Option. This operation is possible only when option
fonts are installed in the printer.
Press the key.
The letter before the number indicates the type of
font as follows:
Press the ENTER key. A blinking question mark (?)
appears.
Emulation
? PCL 6
Emulation
? KPDL
>Print KPDL Errs
OFF
>Print KPDL Errs
? OFF
>Print KPDL Errs
? ON
3
4
5
6
7
8
9
10
Setting the Default Font
Font >
>Font Select >
Internal
>> I000
Letter Description
I Internal fonts
S Soft (download) fonts
M Fonts in an option memory card
H Fonts in a RAM disk or hard disk
O Fonts in an option ROM
>>?I000
1
2
3
4
5