Kyocera FS-6020 - Maximum Space Assigned to Temporary Code Jobs; Maximum Space Assigned to Permanent Code Jobs

Chapter 1 Using the Operator Panel
1-41
Press the or key to increase or decrease the val-
ue at the blinking cursor. The value can be set be-
tween 0 and 50. Use the and keys to move the
cursor right and left.
When the desired maximum number of jobs is set,
press the ENTER key.
Press the MENU key. The message display returns to
Ready.
Maximum Space Assigned to Temporary Code
Jobs
This changes the hard disk space that holds temporary code
jobs. The default size is about 1/6 of the total hard disk
space. For example, the default size is 50 MB for 340 MB
hard disk and 150 MB for 1 GB hard disk. The actual maxi-
mum size depends on the size of free hard disk space, howev-
er.
Press the MENU key.
Press the or key repeatedly until e-MPS > ap-
pears.
Press the key.
Press the or key repeatedly until >e-MPS
Configuration > appears.
Press the key.
Press the or key repeatedly until >>Temp.
Code JOB Size appears.
To change the maximum disk space, press the
ENTER key. A blinking cursor (_) appears.
Press the or key to increase or decrease, re-
spectively, the value at the blinking cursor. Use the
and keys to move the cursor right and left. You
can change the maximum space from 0 to 9999
(megabytes).
Press the ENTER key.
Press the MENU key. The message display returns to
Ready.
Maximum Space Assigned to Permanent Code
Jobs
This changes the hard disk space that holds permanent code
jobs. The default size is about 1/6 of the total hard disk
space. For example, the default size is 50 MB for 340 MB
hard disk and 150 MB for 1 GB hard disk. The actual maxi-
mum size depends on the size of free hard disk space, howev-
er.
Press the MENU key.
Press the or key and select e-MPS >.
Press the key.
Press the or key repeatedly until >e-MPS
Configuration > appears.
Press the key.
Press the or key and select >>Perm. Code
JOB Size.
Press the ENTER key, the message display shows a
blinking cursor (_).
Press the or key to increase or decrease, re-
spectively, the value at the blinking cursor. Use the
and keys to move the cursor right and left. You
can change the maximum space from 0 to 9999
(megabytes).
Press the ENTER key.
e-MPS >
>e-MPS >
Configuration
>>Temp. Code JOB
Size 0150MB
>>Temp. Code JOB
Size 0150
MB
8
9
10
1
2
3
4
5
6
7
8
e-MPS >
>e-MPS >
Configuration
>>Perm. Code JOB
Size 0150MB
>>Perm. Code JOB
Size 0150
MB
9
10
1
2
3
4
5
6
7
8
9