Kyocera FS-6020 - Configuration Settings

Chapter 1 Using the Operator Panel
1-51
This section explains the following topics:
•Setting the Page Protect Mode
•Setting the Linefeed (LF) Action
•Setting the Carriage-Return (CR) Action
•Setting Wide A4
•Verifying the Total Printed Pages
•Resetting the Remaining Toner Counter
•Selecting the Message Language
•Setting the Automatic Form Feed Timeout
•Turning the Off the Sleep Timer
•Setting the Sleep Timer
•Resetting the Printer
•Resource Protection
•Setting the Alarm (Buzzer)
•Setting the Auto Continue
•Setting the Auto Continue Recovery Time
Although Auto is the default setting and this menu does not
usually appear, Page Protect will be forcibly set to On if a
Print overrun Press GO error occurs due to insufficient
printer memory. Be sure to return this setting to Auto in or-
der to maintain high printer memory efficiency. This can be
done as follows.
Press the MENU key.
Press the or key repeatedly until Page Set >
appears.
Press the key.
Press the or key repeatedly until >Page
Protect appears.
Press the ENTER key. A blinking question mark (?)
appears.
Press the or key repeatedly until Auto ap-
pears.
Press the ENTER key.
Press the MENU key. The message display returns to
Ready.
This procedure instructs the printer what to do when it re-
ceives a linefeed code (character code 0AH).
Press the MENU key.
Press the or key repeatedly until Page Set >
appears.
Press the key.
Press the or key repeatedly until >LF Action
appears.
Press the ENTER key. A blinking question mark (?)
appears.
Press the or key repeatedly until desired line-
feed action appears.
LF only A linefeed is performed. (default)
CR and LF A linefeed and carriage return are
performed.
Ignore LF The linefeed is ignored.
When the desired action is displayed, press the
ENTER key.
Press the MENU key. The message display returns to
Ready.
This procedure instructs the printer what to do when it re-
ceives a carriage-return code (character code 0DH).
Press the MENU key.
Configuration
Setting the Page Protect Mode
Page Set >
>Page Protect
On
>Page Protect
? On
>Page Protect
? Auto
1
2
3
4
5
6
Setting the Linefeed (LF) Action
Page Set >
>LF Action
LF only
>LF Action
? LF only
Setting the Carriage-Return (CR) Action
7
8
1
2
3
4
5
6
7
8
1