Chapter 1 Using the Operator Panel
1-40
Press the ENTER key. A blinking question mark (?)
appears.
Press the ENTER key. The document in the mailbox
is printed and automatically deleted from the mail-
box after printing is completed.
Printing a List of VMBs
A Virtual Mailbox list includes the jobs currently stored in
the mailboxes.
Press the MENU key.
Press the or key repeatedly until e-MPS > ap-
pears.
Press the key.
Press the or key repeatedly until >List of
VMB appears.
Press the ENTER key. A question mark (?) appears.
Press the ENTER key again. The printer prints a list
of jobs currently posted in the virtual mailboxes as
shown below. The mailbox (tray) with document(s)
stored is marked with
in the list.
You can change the following parameters for e-MPS opera-
tion:
• Maximum number of quick copy/proof-and-hold jobs
• Maximum space assigned to temporary code jobs
• Maximum space assigned to permanent code jobs
• Maximum space assigned to virtual mailboxes
The total amount of storage areas specified must not exceed
the total size of the hard disk. Otherwise, you may only be able
to accommodate print jobs of a smaller amount of print jobs
than specified.
Changing the Maximum Number of Quick Copy/
Proof-and-Hold Jobs
This changes maximum number of quick copy/proof-and-hold
jobs from 0 to 50. The default is 32.
Press the MENU key.
Press the or key repeatedly until e-MPS > ap-
pears.
Press the key.
Press the or key repeatedly until >e-MPS
Configuration > appears.
Press the key.
Press the or key repeatedly until >>Quick
Copy appears.
Press the ENTER key. A blinking cursor (_) appears.
>Print VMB Data
Tray001?
e-MPS >
>List of VMB
>List of VMB ?
5
6
1
2
3
4
5
6
VIRTUAL MAIL BOX LIST
Changing the e-MPS Configuration
NOTE
e-MPS >
>e-MPS >
Configuration
>>Quick Copy
32
>>Quick Copy
32
1
2
3
4
5
6
7
To Next Page
Loading...
