Chapter 1 Using the Operator Panel
1-12
To use this function, the network interface card must be installed
on the printer.
You can print out a status page for the option network inter-
face. The option network status page shows the firmware ver-
sion, the network addresses, and other information under
various network protocols about the network interface. The
default setting is Off (print disabled). When On (print) is se-
lected, the option network status page will be output after the
printer status page.
Printing out a network interface status page may not be possible
with some optional network interface cards. For details, see the
manual for the network interface.
Press the MENU key.
Press the or key repeatedly until Interface
> appears.
Press the ENTER key. A blinking question mark (?)
appears.
Press the or key repeatedly until Option ap-
pears.
Press the ENTER key again. The question mark (?)
disappears.
Press the key and then press the or key re-
peatedly until the message display indicates
>Opt. StatusPage.
The default setting is Off. Change it as follows.
Press the ENTER key. A blinking question mark (?)
appears.
Select On using the or key.
Press the ENTER key again.
Press the MENU key. The message display returns to
Ready.
Network Status Page
Printing the Option Network Status Page
NOTE
NOTE
Interface >
Parallel
Interface
? Parallel
Interface
? Option
Interface >
Option
>Opt. StatusPage
Off
1
2
3
4
5
6
>Opt. StatusPage
? Off
>Opt. StatusPage
? On
>Opt. StatusPage
On
7
8
9
10
NETWORK STATUS PAGE
Page 1 of 4
To Next Page
Loading...
