Kyocera FS-6020 - Setting the Printer; Resource Protection

Chapter 1 Using the Operator Panel
1-55
The procedure described below resets the printer’s tempo-
rary conditions, such as the current unit of measurement,
page orientation, font, character code set, margins, etc., set
by commands to their default values.
Press the MENU key.
Press the or key repeatedly until Others > ap-
pears.
Press the key.
Press the or key repeatedly until >Printer
Reset appears.
Press the ENTER key. A question mark (?) appears.
Press the ENTER key again. Self test appears
while the printer is resetting itself, then Please
wait followed by Ready.
When you switch from the PCL 6 emulation to another, all
downloaded fonts and macros are deleted. In either of the fol-
lowing two resource protection modes, resource protection
preserves these PCL resources in memory so that they are
available as intact when you change the emulation back to
PCL 6.
You can select either of the following two resource protection
modes to enable this function.
Permanent: You can store such permanent PCL resources
as fonts, macros, and symbol sets in the
printer’s memory when switching to another
emulation.
Perm / Temp: You can store both permanent and temporal
PCL resources in the printer’s memory when
switching to another emulation.
The extension memory should be installed in the printer in ad-
vance to set the resource protection. See Chapter 6 Option
Units.
Press the MENU key.
Press the or key repeatedly until Others > ap-
pears.
Press the key.
Press the or key repeatedly until >Resource
Prot. appears.
Press the ENTER key. A blinking question mark (?)
appears.
Press the or key to display the desired mode.
The display changes as shown below.
Off (default)
Permanent
Perm / Temp
Resetting the Printer
Others >
>Printer Reset
>Printer Reset ?
Self test
Please wait
Ready
1
2
3
4
5
6
Resource Protection
NOTE
Others >
>Resource Prot.
Off
>Resource Prot.
? Off
1
2
3
4
5
6