e-MPS
1-71
8
Press the or key to increase or decrease the value at the blinking
cursor. The value can be set between 0 and 50. Use the > and < keys
to move the cursor right and left.
9
When the desired maximum number of jobs is set, press the ENTER
key.
10
Press the MENU key. The message display returns to Ready.
Maximum Space Assigned to Temporary Code Jobs
This changes the Microdrive space that holds temporary code jobs. You can
change the maximum space from 0 to 9999 (megabytes). The actual
maximum size depends on the size of free hard disk space, however. The
default size is 50 MB.
1
Press the MENU key.
2
Press the or key repeatedly until e-MPS > appears.
3
Press the > key.
4
Press the or key repeatedly until >e-MPS Configuration >
appears.
5
Press the > key.
6
Press the or key repeatedly until >>Temp. Code JOB Size
appears.
7
To change the maximum disk space, press the ENTER key. A
blinking cursor (
) appears.
e-MPS >
>e-MPS >
Configuration
>>
Temp. Code JOB
Size 050MB
>>
Temp. Code JOB
Size 050MB
To Next Page
Loading...
