Lantronix EDS-MD Series User Manual

6: Network Settings
EDS-MD® Medical Device Server User Guide 40
To Configure Network 1 (eth0) Interface Settings
Using Web Manager
 To modify Ethernet (eth0) settings, click Network on the menu and select Network 1 ->
Interface -> Configuration.
Using the CLI
 To enter the eth0 command level: enable -> config -> if 1
Using XML
 Include in your file: <configgroup name="interface" instance="eth0">
Network 1 (eth0) Link Settings
Physical link parameters can be configured for an Ethernet (eth0) Network Link (see
Table 6-2).
Table 6-2 Network 1 (eth0) Link Settings
Notes:
 When speed is Auto, duplex must be Auto or Half.
 When speed is not Auto, duplex must be Half or Full.
 Fixed speed Full duplex will produce errors connected to Auto, due to duplex
mismatch.
To View or Configure Link 1(eth0) Settings
Using Web Manager
 To view Ethernet (eth0) Status, click Network on the menu and select Network 1 -> Link.
Using the CLI
 To enter the eth0 command level: enable -> config -> if 1
Network 1 Ethernet (eth0)
Link Settings
Description
Speed Select the Ethernet link speed. (Default is Auto)
 Auto = Auto-negotiation of Link Speed
 10 Mbps = Force 10 Mbps
 100 Mbps = Force 100 Mbps
 1000 Mbps = Force 1000 Mbps
Duplex Select the Ethernet link duplex mode. (Default is Auto)
 Auto = Auto-negotiation of Link Duplex
 Half = Force Half Duplex
 Full = Force Full Duplex

Lantronix EDS-MD Series Specifications

General

Brand	Lantronix
Model	EDS-MD Series
Category	Server
Language	English