8: Terminal and Host Settings
EDS-MD® Medical Device Server User Guide 60
To Configure Host Settings
Note: The following section describes the steps to view and configure Host 1 settings;
these steps apply to other host instances of the device.
Using Web Manager
To configure a particular Host, click Host on the menu and select Host 1 -> Configuration.
Using the CLI
To enter the Host command level: enable -> config -> host 1
Using XML
Include in your file: <configgroup name=”host” instance=”1”>
SSH Username Appears if you selected SSH as the protocol. Enter a username to select a pre-
configured Username/Password/Key (configured on the SSH: Client Users page),
or leave it blank to be prompted for a username and password at connect time.
Note: This configuration option is only available when SSH is selected for
Protocol.
Remote Address Enter an IP address for the host to which the device will connect.
Remote Port Enter the port on the host to which the device will connect.
Host Settings Description
To Next Page
Loading...
Need help?
General