6: Network Settings
EDS-MD® Medical Device Server User Guide 42
Network 2 (eth1) Link Settings
Physical link parameters can be viewed and configured for an Network 2 (eth1) Interface (see
Table 6-4) and a Network 2 (eth2) Interface (see Table 6-5).
Table 6-4 Network 2 (eth1) Link Settings
To View or Configure Link 2 (eth1) Settings
Using Web Manager
In Network 2 Link, you can view and modify the current operational settings.
To view Ethernet (eth1) Link Status, click Network on the menu and select Network 2 ->
Link.
Using the CLI
To enter the eth1 command level: enable -> config -> if 2
Using XML
Include in your file: <configgroup name="link" instance="eth1">
Network 2 Ethernet (eth1)
Link Settings
Description
Speed Select the wlan0 link speed. (Default is Auto)
Auto = Auto-negotiation of Link Speed
10 Mbps = Force 10 Mbps
100 Mbps = Force 100 Mbps
1000 Mbps = Force 1000 Mbps
Duplex Select the wlan0 link duplex mode. (Default is Auto)
Auto = Auto-negotiation of Link Duplex
Half = Force Half Duplex
Full = Force Full Duplex
To Next Page
Loading...
Need help?
General