LeCroy 9400A User Manual

The 9400A sets the VALUE ADAPTED bit:
- if an out-of-range value is given.
The 9400A sets the ENVIRONMENT ERROR:
- If the SELECTed trace is OFF.
6) TIME MAGNIFIER (TM) , < ?
< [ 0 to6 ] >
TIME MAGNIFIER is applied to the SELECTed trace. It may only be
applTed to traces EXPAND A or EXPAND B.
The value 0 corresponds to no expansion. Each increment of I
corresponds to the next lower time base value (relative to the
original trace). The value 6 therefore allows an expansion by
factor of I00.
The 9400A sets the VALUE ADAPTED bit:
- if an out-of-range positive value
generate a semantic error.
is given. Negative values
The 9400A sets the ENVIRONMENT ERROR:
- if the SELECTed trace is OFF.
- if the SELECTed trace is neither EXPAND A nor EXPAND B.
7) HOR POSITION (HP) , <
>
, < [ 0.0000 DIV to i0.0000 DIV ] >
when the source trace corresponds to a single
waveform (acquired in single shot or with
INTERLEAVED ON).
, < [ 1 to max ] >
when the source trace corresponds to multiple
waveforms (acquired in SEQNCE).
The parameter indicates the number of the
sequence to be displayed. "max" depends on the
selected number of segments (see SEGMENTS).
HOR POSITION will be applied to the SELECTed trace. It may only be
applied to traces EXPAND A or EXPAND B. The parameter in the range
0 to I0 divisions corresponds to The CENTER of the intensified
region on the original trace. The smallest possible step is
0.0004 div.
The 9400A sets the VALUE ADAPTED bit:
- if an out-of-range value is given (Interleaved Sampling or Single
Shot).
- if a positive out-of-range value is given (SEQNCE). Negative
zero values generate a semantic error.
7-18
Remote Operations

LeCroy 9400A Specifications

General

Brand	LeCroy
Model	9400A
Category	Test Equipment
Language	English