The following pop-up messages appears if the operator
attempts to activate a control panel while parked
regeneration is in process. (Figure 4-25)
Figure 4-25. Parked Regen Active Alert
If the operator attempts to crank the engine or activate
a control panel console while one or more joystick(s) is
out of neutral, an alert message appears. (Figure 4-26)
NOTE: The joystick in the wrong position will be
shown in red.
Figure 4-26. Joysticks Must Be in Neutral Alert
The following message alert appears if the paver in high
gear with the conveyors or augers on. (Figure 4-27)
Figure 4-27. High Gear Pave Alert
If the operator attempts to shift from high to low gear
while traveling too fast, the following message pops-up
on the screen. (Figure 4-28)
NOTE: The downshift will automatically occur if the
operator slows down.
Figure 4-28. Downshift Inhibited Alert
44
Operation
LeeBoy Model 5300B Compact Paver 4-25
To Next Page
Loading...
