LeeBoy 8515D - PV480 Powerview Display

4
LeeBoy 8515D Conveyor Paver 4-5
Operation
PV480 Powerview Display
Gauge Screen
The gauge screen displays ve (5) dial gauges and
three (3) digital gauge options. (Figure 4-2)
Figure 4-2. Gauge Screen
The gauge screen displays ve (5) dial gauges and
three (3) digital gauge options:
1 - Engine Speed/RPM
2 - Engine Coolant Temperature
3 - After Treatment DPF Outlet Gas Temperature
4 - Electrical Potential Voltage
5 - Actual Engine Torque Percentage
6 - Oil Pressure – Lamp Only
7 - Fuel Level
8 - Engine Total Hours of Operation
Set Points and Throttle Speed
Used to select preset engine throttle speeds.
Use the rst button to select set points while
not in the menu. Select desired default throttle
speed using buttons. The default speeds
are: 1300 RPM, 1500 RPM, 1800 RPM, 2000
RPM and 2200 RPM, as shown in Figure 4-3.
1 2 3 4 5
1000 RPM
2200 RPM
1400 RPM 1600 RPM 2600 RPM
Figure 4-3. Engine Throttle Speeds Screen
Use the second button to switch between DPF
commands and Speed/Throttle to change functions of
buttons 4 and 5 (manually adjusts engine throttle).
NOTE: LeeBoy sets the generator for optimum
performance at the 2200 RPMs. It is
recommended that you use the 2200 RPM
preset. The generator will perform at other
lower RPM levels, but not at peak levels.
DPF Commands
With “DPF commands” use button 5 to inhibit a Parked
Regen Request.
Parked Regen should be carried out as
soon as possible after a Parked Regen Request has
been given. Failure to do so may result in damage to
the engine.