LeeBoy L600 - Burner System; Electrical

BURNER SYSTEM
NEVER store combustible materials
near the distributor, especially near the burner
system.
Excessive smoke or trouble starting the diesel burner
system means the burner cover must be removed for
cleaning or adjustment.
• Remove the burner cover every month to check and
thoroughly clean the burner system if needed.
• Inspect the LPG burner and its mounting system daily:
• Tighten, repair or replace components, hoses and
ttings as needed.
• Check propane level and rell when needed.
• Always check the valves and fuel lines before lighting
burners. If a leak is suspected, use soapy water to
identify the source of the leak.
• Tighten ttings that are leaking and replace any
damaged parts.
• Use a wrench to tighten the burner mounting
hardware before lighting the burners.
• Contact your authorized dealer to check (or replace if
needed) the ue liner and tubes annually.
• Inspect the ue tubes for cracks or other damage.
ELECTRICAL
Battery (Option)Battery (Option)
If equipped with the optional electric starter system,
your unit will include a 12-volt negative-ground battery
that provides power for the starter. It is contained in
a hinged battery box mounted onto the trailer frame.
(Figure 5-9)
Fire Hazard! Keep sparks and ames
away from the batteries as electrolyte gas is highly
ammable.
NEVER allow battery uid to come
into contact with clothing, skin or eyes. ALWAYS
wear safety goggles and protective clothing when
servicing the battery. If battery uid contacts eyes or
skin, immediately ush the affected areas with water
and obtain prompt medical treatment.
Battery
Box
(Shown Open)
Figure 5-9. Battery
• Keep the battery clean and wash it when dirt buildup is
excessive.
• Be sure the terminals and battery posts are
thoroughly cleaned and that battery cable terminals
are tight.
• Dirty or loose connections can create high electrical
resistance and permit arcing.
• Keep the battery fully charged during cold weather
and when machine has been idle for extended
periods.
• DO NOT pressure-wash electrical components.
Protect the battery and other electrical components
when washing the distributor.
Maintenance
L300 and L600 Tack Distributors5-10