Parameter setting
Important notes
7
7.1

7.1−2
EDSVF9383V EN 7.1−04/2012
You need the parameter setting / operating software »Global Drive Control«
(GDC) or »Global Drive Control easy« (GDC easy) and an interface for
communication:
Æ’ Interface for system bus (CAN) (preset in GDC):
– PC system bus adapter
Æ’ Serial interface for LECOM:
– Communication module LECOM−A/B (RS232/RS485)
EMF2102IB−V001
The parameter setting /operating software of the Global Drive Control
family are easy−to−understand and tools for the operation, parameter
setting and diagnostics or Lenze drive controllers.
GDC easy
ESP−GDC2−E
GDC
ESP−GDC2
Supply Free download from the
internet at
www.lenze.com
Program package must be
charged for
Operation in interactive mode yes yes
Comprehensive help functions yes yes
Menu "Short setup" yes yes
Monitor windows for displaying
operating parameters and for
diagnostic purposes
yes yes
Saving and printing of parameter
settings as code list
yes yes
Loading of parameter files from the
controller to the PC
yes yes
Storing of parameter files from the PC
in the controller
yes yes
Function block editor no yes
Technology functions for 9300 Servo no yes
Oscilloscope function for 9300 Servo
and 9300 vector
no yes
Detailed description Online help of the
program
Online help of the
program
Detailed information can be found in the documentation of the
corresponding bus system.
Parameter setting via PC
Parameter setting via bus
system
To Next Page
Loading...
Need help?
General
