Parameter setting
Parameter setting with the XT EMZ9371BC keypad
Activating password protection
7
7.2
7.2.7

7.2−9
EDSVF9383V EN 7.1−04/2012
7.2.7 Activating password protection
 Note!
Æ’ If the password protection is activated (C0094 = 1 ... 9999), you
only have free access to the user menu.
Æ’ To access the other menus, you must enter the password. By
this, the password protection is annulled until you enter a new
password.
ƒ Please observe that the password−protected parameters can
be overwritten as well when transferring the parameter sets
to other standard devices. The password is not transferred.
Æ’ Do not forget your password! If you have forgotten your
password, it can only be reset via a PC or a bus system!
Step Key
sequence
Action
1. Select the "USER menu"  )  * Change to the user menu using the arrow
keys
2. Change to the code level  Display of code C0051 "MCTRL−NACT"
3. Select C0094  Display of code C0094 "Password"
4. Change to the parameter level  Display "0" = no password protection
5.
Set password
A  Select password (1 ... 9999)
B (  Confirm password
6.
Change to the code level
A  Display of the operating level
B  Display of C0094 and "Password"
7. Change to the "USER menu" * * )
The password protection is active now.
You can only quit the user menu if you re−enter the password and confirm it with
(.
Step Key
sequence
Action
1. Change to the code level in the
user menu

2. Select C0094  Display of code C0094 "Password"
3. Change to the parameter level  Display "9999" = password protection is
active
4.
Enter password
A ) Set valid password
B (  Confirm
The password protection is deactivated by
entering the password once again.
5.
Change to the code level
A  Display of the operating level
B  Display of C0094 and "Password"
The password protection is deactivated now. All menus can be freely accessed again.
Activate password protection
Remove password protection
To Next Page
Loading...
Need help?
General
