Lenze EVS9321-Ex System Manual

Troubleshooting and fault elimination
Drive behaviour in the event of faults
9
9.3

9.3−1
EDSVF9383V EN 7.1−04/2012
9.3 Drive behaviour in the event of faults
The controller responds differently to the three possible fault types TRIP,
message, or warning:
TRIP (display in keypad XT:  &)
ƒ Switches the power outputs U, V, W to a high−resistance state until
TRIP reset is executed.
ƒ The fault indication is entered into the history buffer as "current fault"
in C0168/1.
ƒ The drive coasts without any control!
ƒ After TRIP reset ( 9.5−5):
– The drive travels along the ramps to its setpoint.
– The fault indication is moved to C0168/2 as "last fault".
Message (display in keypad XT:  &)
ƒ Switches the power outputs U, V, W to a high−resistance state.
ƒ The fault indication is entered into the history buffer as "current fault"
in C0168/1.
ƒ In case of a fault £5 s:
– The drive coasts without any control as long as the message is active!
– If the message is not active anymore, the drive travels to its setpoint
with maximum torque.
ƒ In case of a fault > 5 s:
– The drive coasts without any control as long as the message is active!
– If the message is not active anymore, the drive travels to its setpoint
along the adjusted ramps.
ƒ If the message is not active anymore, the fault indication is moved to
C0168/2 as "last fault".
"Heatsink overtemperature" (keypad XT:OH  &)
ƒ The drive continues to travel in a controlled way!
ƒ The warning signal goes off when the fault is not active anymore.
"Error in motor phase" (keypad XT:LP1)
"PTC monitoring" (keypad XT:OH51)
ƒ The drive continues to travel in a controlled way!
ƒ The fault indication is entered into the history buffer as "current fault"
in C0168/1.
ƒ After TRIP reset, the fault indication is moved to C0168/2 as "last
fault".
TRIP
Messages
Warnings

Lenze EVS9321-Ex Specifications

General

Brand	Lenze
Model	EVS9321-Ex
Category	Controller
Language	English