Appendix
Index
14
14.2

14.2−1
EDSVF9383V EN 7.1−04/2012
14.2 Index
A
Acceleration, 6.10−1
Acceleration time Tir, additional setpoint of NSET, 8.5−19
Accessories, 13−1
− external brake resistor, 12.1−1
− General, 13.1−1
− Type−specific, 13.2−1
Activating the incremental encoder, 6.7−1
Actual motor current, 8.2−27 , 8.2−42 , 8.5−7 , 9.1−1
Actual motor voltage, 8.2−27 , 8.2−42 , 8.5−6 , 9.1−1
Actual speed value, 8.2−27 , 8.2−42 , 8.5−6 , 9.1−1
Additional setpoint, 8.5−6
Ambient conditions
− climatic, 3.1−2
− electrical, 3.1−2
− mechanical, 3.1−2
Analog inputs
− setting input range with jumper X3, 5.6−9
− Signals, 6.5−4
− terminal assignment, 5.6−9
Analog outputs
− Configuration, 6.5−6
− Signals, 6.5−6
− terminal assignment, 5.6−9
Application, as directed, 1.2−1
Application as directed, 1.2−1
Application datum, Display, 9.1−1
B
Basic function, 8.5−2
Brake operation, with external brake resistor, 12.1−1
Brake resistors, Selection, 12.1−1
Brake transistor, 12.3−1
Braking, 6.10−1 , 12−1
Braking operation, 12−1
− in the network, 10.4−1 , 12.4−1
Bus off, 8.3−2
C
Cable
− For control connections, 5.3−3
− for the motor connection, 5.3−2
Cable cross−sections, 10.2−1
Calibration, Application datum, 9.1−1
CAN bus identifier, 8.5−23
CE conformity, 1.2−1
CE−typical drive system, 5.4−1 , 5.5−1
Changing parameters
− EMZ9371BC keypad, 7.2−7 , 7.2−8
− Keypad EMZ9371BC, 7.2−4 , 7.2−6 , 7.2−9
Changing the direction of rotation, 6.10−5
Clamp operation, 9.4−2
Code, 7.1−1
Code table, 8.5−1
Commissioning, 6−1
− before switching on, 6.1−1
− Entry of motor data, 6.6−1
Communication modules, 5.10−1
Compensation equipment, Interaction with, 5.2−2
To Next Page
Loading...
Need help?
General
