Safety instructions
General safety information
2
2.1

2.1−3
EDSVF9383V EN 7.1−04/2012
ƒ The components are maintenance−free if the required operating
conditions are observed.
Æ’ If the cooling air is polluted, the cooling surfaces may be contaminated
or the air vents may be blocked. Under these operating conditions, the
cooling surfaces and air vents must be cleaned at regular intervals.
Never use sharp objects for this purpose!
Æ’ Only replace defective fuses in the deenergised state to the type
specified.
Æ’ After the system has been disconnected from the supply voltage, live
components and power connections must not be touched immediately
because capacitors may be charged. Please observe the corresponding
notes on the device.
Æ’ Recycle metals and plastic materials. Ensure professional disposal of
assembled PCBs.
Maintenance and servicing
Disposal
To Next Page
Loading...
Need help?
General
