DSS-1000 User Manual
1.2 Connecting Devices
Connection Architecture
The diagram below illustrates a sample connection within a local area network.
Local Area Network Connection Architecture
1. Connect the power adaptor to DSS-1000 and power outlet (see Preparing the Power
Adaptor on page 16).
NOTE: This step may be skipped if a Power-over-Ethernet (PoE) switch or injector will
be connected to DSS-1000.
2. Connect a monitor to DSS-1000 via HDMI or Composite port connection (see
Connecting to Local Display on page 17).
3. Connect a USB mouse.
4. Connect DSS-1000 to a Power-over-Ethernet (PoE) switch or injector.
NOTE: If using the bundled power adaptor, a non-PoE switch may also be used.
5. Connect the cameras to the switch (see Connecting the Cameras on page 18).
15
To Next Page
Loading...
