DSS-1000 User Manual
Setting Preset Tours on the Remote Client
Several preset points can be grouped into a “Tour” which directs the the series of preset points at specific interval
time. Up to 32 tours can be set on DSS-1000.
The tour configuration is saved only on DSS-1000, not on the camera side.
How to Create / Modify Tours
To create tours, make sure one or more preset points have already been created. The tour
configuration on DSS-1000 is not synced with the tour configuration on the camera side.
1. On the Setup screen, click Camera.
2. Before creating a tour, the preset points must be created first (see Setting Preset
Points on the Remote Client on page 112).
3. Click the Preset Tour tab.
4. On Tour, select the tour ID from the list. A default name is give to the tour; retain or
modify Name, as preferred.
5. On Preset Point, select the preset point to include on the tour and specify the Dwell
time (in seconds). Dwell time is the amount of time that the camera will remain in the
preset point.
6. Click Add. The preset point is added to the list.
113
To Next Page
Loading...
Need help?
General
