DSS-1000 User Manual
Local Display
The Local Display page allows users to show or hide information, such as the IP address,
system date and time, or event trigger icons, on the Live View screen. By default, all
options are enabled.
1. On the Setup screen, click System > Local Display.
2. By default, all options are enabled. To disable a function, remove the check from
its corresponding box.
Hide mouse cursor when the system is idle: If checked, the mouse cursor is hidden
from the Local display if there is no mouse movement within 5 seconds.
Show system time: If checked, the system date and time is displayed on the bottom
of the Live View screen.
Show system IP address: If checked, the system IP address is displayed on the
bottom of the Live View screen.
Show camera name: If checked, the camera name is displayed on the upper left
corner of the channel.
Show camera IP address: If checked, the camera IP address is displayed on the
upper left corner of the channel. For security reasons, it is recommended to uncheck
this function to hide the IP address from showing on the local display.
Show camera event trigger: If checked, an event trigger icon, such as motion
detection, will appear on the upper right corner of the channel when an event occurs.
Show grid line: If checked, the lines separating the camera channels are displayed
on the Live View screen.
3. When modifications are done, click Save to apply and save the changes. Or, click Reset
to re-check all the boxes back to its default.
96
To Next Page
Loading...
Need help?
General
