DSS-1000 User Manual
Connecting the Cameras
DSS-1000 can decode up to 16 IP cameras or video encoders and display the videos
through an HDMI (1080p) or composite monitor or display remotely via PC or a mobile client.
To connect a camera, do the following:
1. Connect the camera to a PoE switch, within in the same network segment as DSS-
1000, using an Ethernet cable.
2. Configure the IP address of the camera, if necessary (please refer to the camera
hardware manual on how to do this).
3. Once ready, access DSS-1000 user interface to search and finalize the
camera connection (see Quick Setup on page 23).
18
To Next Page
Loading...
