EP SETUP
EP Defaults
This setting restores each printer setting listed in EP SETUP to its factory default value. Sometimes this is used to help
correct print quality problems.
To restore the EP defaults:
1 From the Diagnostics menu, navigate to:
EP Setup > EP Defaults
2 Select Restore to restore the default values, or press X to exit without changing the settings.
Fuser Temperature (Fuser Temp)
This setting adjusts the fuser temperature to solve problems with paper curl on low‑grade paper and/or melting of
letterheads on some papers.
To adjust this setting:
1 From the Diagnostics menu, navigate to:
EP Setup > Fuser Temp
2 Press OK or touch to save any changes.
Transfer Adjust
This setting controls the transfer roll algorithm.
To adjust this setting:
1 From the Diagnostics menu, navigate to:
EP Setup > Transfer Adjust
2 Press OK or touch to save any changes.
Print Contrast
This setting controls the developer voltage offset.
To adjust this setting:
1 From the Diagnostics menu, navigate to:
EP Setup > Print Contrast
2 Press OK or touch to save any changes.
Charge Roll
This setting controls the charge roll voltage.
7015
Service menus
166
To Next Page
Loading...
