Bottom removals
Power supply removal
1 Remove the left cover. See “Left cover removal” on page 209.
2 Remove the rear door and cover. See “Rear exit door removal” on page 301 and “Rear cover removal” on page
302.
3 Disconnect the fuser cable (A) from the power supply, and disconnect the cable (B) from the left side of the printer.
AB
4 Position the printer so that it sits on its right side.
5 Remove the right tray guide. See “Tray guide removal” on page 298.
7015
Repair information
272
To Next Page
Loading...
