Lexmark MX310 Series - Insufficient memory for Flash Memory Defragment operation [37]; Insufficient memory, some Held Jobs were deleted [37]; Insufficient memory, some held jobs will not be restored [37]; Insufficient memory to collate job [37]

Entering recovery mode
This mode will allow the printer to boot from a secondary set of instructions to allow a code flash to the printer. Code
can be flashed from a PC via USB.
1 Turn off the printer.
2 Press and hold the 7, 2, and 8 buttons simultaneously.
3 Turn on the printer.
4 Release the buttons after 10 seconds.
Accessing the Network SE menu
This menu contains settings for fine tuning the communication settings for the network interfaces and protocols.
1 Navigate to:
Networks/Ports > Standard Network > Std Network Setup.
2 Press and hold 6, 7, and 9 simultaneously.
Service Engineer menu
Accessing the service engineer (SE) menu
From a Web browser on a host PC, add /se to the printer IP address.
Service engineer (SE) menu
This menu should be used as directed by the next level of support.
Top level menu Intermediate menu
Print SE Menus
General Copyright — Displays copyright information
Code Revision Info
• Network code level — Displays network code level
• Network Compile Info — Displays network compile information
• Printer Code Level — Displays printer code information
• Printer Compile Info — Displays compile information
History
• Print History
• Mark History
• History Mode
MAC
• Set Card Speed
• LAA
• Keep Alive
7015
Service menus
186