Lexmark MX310 Series - Speaker Cable Removal

3 Remove the three screws (A) securing the control panel assembly to the scanner assembly.
A
4 Lift the control panel assembly, disconnect the ribbon cable (JUICC1) from the UICC card, and then feed the ribbon
cable through the wire channel.
Speaker cable removal
1 Remove the left cover. See “Left cover removal” on page 209.
2 Remove the controller board shield. See “Controller board shield removal” on page 234.
3 Remove the fan.
4 Remove the scanner front cover. See “Scanner front cover removal” on page 315.
7015
Repair information
329