ADF cable removal
1 Remove the ADF unit. See “ADF unit removal” on page 316.
2 Using a flat-blade screwdriver, remove the cable cover from the rear of the scanner assembly.
3 Remove the scanner assembly from the MFP.
4 Route the cable through the flatbed assembly, and remove it from the flatbed assembly.
USB cable removal
1 Remove the right cover. See “Right cover removal” on page 226.
2 Remove the RIP board shield. See “Controller board shield removal” on page 234.
3 Remove the fan.
4 Disconnect the MFP wireless cable from the RIP board.
7015
Repair information
325
To Next Page
Loading...
