13 Rotate, and then remove the 2nd pickup bushing.
14 Pull out the shaft, and remove the ACM.
Pick/lift motor gearbox removal
1 Remove the left cover. See “Left cover removal” on page 209.
2 Remove the rear door and cover. See “Rear exit door removal” on page 301 and “Rear cover removal” on page
302.
3 Remove the power supply. See “Power supply removal” on page 272.
4 Remove the power supply shield. See “Power supply shield removal” on page 273.
5 Remove the duplex. See “Duplex removal” on page 274.
6 Remove the ACM assembly. See “ACM assembly removal” on page 288.
7 Position the printer so that it sits on its left side.
7015
Repair information
297
To Next Page
Loading...
