Lexmark MX310 Series - Media Present Sensor Removal

9 Route off the cable, and then remove the index sensor.
A
Media present sensor removal
1 Remove the left cover. See “Left cover removal” on page 209.
2 Remove the rear door and cover. See “Rear exit door removal” on page 301 and “Rear cover removal” on page
302.
3 Remove the power supply. See “Power supply removal” on page 272.
4 Remove the power supply shield. See “Power supply shield removal” on page 273.
5 Remove the duplex. See “Duplex removal” on page 274.
6 Position the printer so that it sits on its left side.
7015
Repair information
280