Lexmark MX310 Series - ADF Hinge Removal; Control Panel Ribbon Cable Removal; Flatbed Assembly Removal

ADF hinge removal
Note: The removal shown is for the left ADF hinge. The right ADF hinge is removed in a similar manner.
1 Remove the ADF assembly. See “ADF unit removal” on page 316.
2 Remove the four screws (A) securing the ADF hinge to the ADF assembly.
A
Flatbed assembly removal
1 Remove the ADF assembly. See “ADF unit removal” on page 316.
2 Remove the scanner assembly from the MFP. See “Scanner assembly removal” on page 319.
3 Remove the operator panel assembly. See “Control panel assembly removal” on page 249.
4 Remove the ADF cable. See “ADF cable removal” on page 325.
5 Remove the USB wireless cable. See “USB wireless cable removal” on page 326.
6 Remove the control panel USB cable. See “USB cable removal” on page 325.
7 Remove the speaker cable. See “Speaker cable removal” on page 329.
8 Remove the wireless control panel cover.
Control panel ribbon cable removal
1 Remove the left cover. See “Left cover removal” on page 209.
2 Remove the scanner front cover. See “Scanner front cover removal” on page 315.
7015
Repair information
328