Lexmark MX310 Series - Defective flash detected [51]; Error reading USB drive. Remove USB.; Error reading USB hub. Remove hub.; Fax memory full

3 Touch Submit.
Press Back to return to the Configuration menu.
Key Repeat Initial Delay
Note: This setting is available on the MS610de model only.
This setting determines the length of delay before a repeating key starts repeating. The range is 0.25–5 seconds, with
increments of 0.25. The default setting is one second.
To adjust this setting:
1 From the Configuration menu, navigate to Key Repeat Initial Delay.
2 Touch the arrow keys to adjust the setting.
3 Touch to save the setting, or press X to return to the Configuration menu without saving any changes.
Key Repeat Rate
Note: This setting is available for touch screen models only.
This setting indicates the number of presses per second for repeating keys. The range is 0.5–30, with increments of 1.
To adjust this setting:
1 From the Configuration Menu, navigate to Key Repeat Rate.
2 Touch the arrow keys to adjust the setting.
3 Touch to save the setting, or press X to return to the Configuration Menu without saving any changes.
Clear Supply Usage History
This setting reverts the supply usage history (number of pages and days remaining) to the factory shipped level.
To clear the supply usage history:
1 From the Configuration menu, navigate to Clear Supply Usage History.
2 Depending on the printer model, press OK or touch Clear Supply Usage History to proceed.
Clear Custom Status
Executing this operation erases any strings that have been defined by the user for the default or alternate custom
messages.
To clear the custom status:
1 From the Configuration menu, navigate to Clear Custom Status.
2 Depending on the printer model, press OK or touch Clear Custom Status to proceed.
7015
Service menus
184