5 Remove the power supply shield. See “Power supply shield removal” on page 273.
6 Remove the duplex. See “Duplex removal” on page 274.
7 Position the printer so that it sits on its left side.
8 Disconnect the cable JACM1 from the controller board.
9 Release the retainer spring (A) from the bracket (B).
10 Remove the screw (C).
A C
B
Trailing edge sensor (MX310, MX410) removal
1 Remove the left cover. See “Left cover removal” on page 209.
2 Remove the right cover. See “Right cover removal” on page 226.
3 Remove the rear door and cover. See “Rear exit door removal” on page 301 and “Rear cover removal” on page
302.
4 Remove the power supply. See “Power supply removal” on page 272.
5 Remove the power supply shield. See “Power supply shield removal” on page 273.
6 Remove the duplex. See “Duplex removal” on page 274.
7 Disconnect the cable JACM1 from the controller board, and cut it near the frame.
7015
Repair information
283
To Next Page
Loading...
