6 Remove the five metal screws (D) and the plastic screw (E) securing the power supply.
D
E
7 Remove the power supply, and then disconnect the cable from the power supply.
Power supply shield removal
1 Remove the left cover. See “Left cover removal” on page 209.
2 Remove the rear door and cover. See “Rear exit door removal” on page 301 and “Rear cover removal” on page
302.
3 Remove the power supply. See “Power supply removal” on page 272.
4 Position the printer so that it sits on its right side.
7015
Repair information
273
To Next Page
Loading...
