7 Remove the ADF unit.
Installation note: After the new ADF is installed, perform scanner manual registration, see “Scanner manual
registration” on page 178 and scanner calibration, see “Scanner calibration” on page 155.
Scanner assembly removal
1 Remove the rear cover. See “Rear cover removal” on page 302.
2 Open the front access cover.
3 Remove the left cover. See “Left cover removal” on page 209.
4 Remove the right cover. See “Right cover removal” on page 226.
5 Remove the RIP shield from the printer frame assembly. See “Controller board shield removal” on page 234.
7015
Repair information
319
To Next Page
Loading...
