8 Remove the ground (B), narrow media/bin full sensor (C), and sensor flag (D).
B
C
D
Redrive assembly removal
1 Remove the right cover. See “Right cover removal” on page 226.
2 Remove the left cover. See “Left cover removal” on page 209.
3 Remove the rear door and cover. See “Rear exit door removal” on page 301 and “Rear cover removal” on page
302.
4 Remove the scanner assembly. See “Scanner assembly removal” on page 319.
5 Remove the top cover. See “Top cover assembly removal” on page 307.
6 Disconnect cable JNRW1 from the controller board.
7 Remove the two screws (A), and then disconnect the reverse solenoid.
Note: Do not disconnect the reverse solenoid cable from the controller board.
7015
Repair information
304
To Next Page
Loading...
