ACM assembly (MX310, MX410) removal
1 Remove the left cover. See “Left cover removal” on page 209.
2 Remove the main drive gearbox. See “Main drive gearbox removal” on page 211.
3 Remove the rear door and cover. See “Rear exit door removal” on page 301 and “Rear cover removal” on page
302.
4 Remove the power supply. See “Power supply removal” on page 272.
5 Remove the power supply shield. See “Power supply shield removal” on page 273.
6 Remove the duplex. See “Duplex removal” on page 274.
7 Remove the ACM clutch. See “ACM clutch removal (MX310, MX410)” on page 219.
Warning—Potential Damage: Do not cut the cable (leave the ACM clutch hanging).
8 Remove the screw (A) and then detach the trailing edge sensor.
A
7015
Repair information
294
To Next Page
Loading...
