Solving print quality problems
129
Troubleshooting
Faint images or repetitive spots
appear on the page.
• Try a different type of print media. Print media designed for
copiers provides the best quality.
• Replace the used print cartridge with a new one. See
Replacing the print cartridge for instructions.
Characters have jagged or uneven
edges, or image quality is poor.
• Change the Print Resolution setting in the print driver,
MarkVision Professional, the control panel, or the Web
pages. Use a print resolution higher than 300 dots per inch
(dpi).
• If you are using downloaded fonts, verify that the fonts are
supported by the MFP, the host computer, and the
application.
The job prints, but the left and top
margins are incorrect.
• Make sure the Paper Size setting is set correctly in the print
driver, MarkVision Professional, the control panel, or the
Web pages.
• Verify that the Print Area setting in MarkVision Professional,
the control panel, or the Web pages is correct. Print a menu
settings page to verify this. For more information, see
Printing the menu settings page.
• Make sure the margins are set correctly in your application.
Printing is too dark. • Change the Toner Darkness setting in the print driver,
MarkVision Professional, the control panel, or the Web
pages.
• Make sure the lines per inch (lpi) setting is not set too high in
the application.
Problem Solution
To Next Page
Loading...
