Lexmark X422 - Page 214

Menus
214
Using the MFP control panel and menus
Paper Saver Allows the images of multiple
pages to be printed on a single
side (or page) of a sheet of print
media.
Some products refer to this as N-
up.
Off One page image is printed on
one side of a sheet.
2 on 1 port. Two page images are printed on
one side of a sheet in portrait
orientation.
2 on 1 land. Two page images are printed on
one side of a sheet in landscape
orientation.
4 on 1 port. Four page images are printed on
one side of a sheet in portrait
orientation.
4 on 1 land. Four page images are printed on
one side of a sheet in landscape
orientation.
For a visual representation of portrait and landscape
orientation, see page 61.
Use the left and right arrow buttons to make a selection.
Margin Shift Creates an additional left margin
when the copy job has narrow
margins, but the job needs a
binding.
0–50 mm short of
the print media
width in 10 mm
increments
(0 mm*)
Use the left and right arrow
buttons to make a selection.
If the additional margin is too
wide, the copy on the page is
cropped.
0–2 inches short of
the print media
width
in 1/4 inch
increments
(0.0*)
Time Stamp Prints the date and time at the top
of every page. The representation
of the date and time changes
based on the country or region.
The default U.S. setting shows this
as a two digit month, two-digit
date, four-digit year, two-digit hour,
and two-digit minutes (MM-DD-
YYYY hh:mm) and default
international countries/regions
setting shows this as a a two-digit
date, two-digit month, four-digit
year, two-digit hour, and two-digit
minutes (DD-MM-YYYY hh:mm).
The date and time stamp is
accurate for each printed copy if
previously set.
Off* Turns the time stamp off, so it
does not print.
On Turns the time stamp on, so it
does print on each job.
Use the left and right arrow buttons to make a selection.
Copy(continued)
Menu item Purpose Values and descriptions