4-72
7014-xxx
Tub assembly removal
1. Remove the flatbed assembly. See “Flatbed removal” on page 4-89.
2. Disconnect the the remaining cables from the controller board.
3. Thread the cables through the tub assembly and top cover.
4. Remove the controller board cage. See “Controller board cage” on page 4-14.
5. Remove the operator panel keyboard. See “Operator panel keypad removal” on page 4-64.
6. Remove the operator panel display. See “Operator panel display removal” on page 4-65.
7. Remove the left rear frame assembly. See “Left rear frame assembly removal” on page 4-70.
8. Remove the right rear frame assembly. See “Right rear frame assembly removal” on page 4-71.
9. Remove the USB cable mount bracket. See “USB cable mount bracket removal” on page 4-68.
10. Remove the operator panel support. See “Operator panel support removal” on page 4-68.
11. Remove the operator panel display rotation support. See “Display rotation support removal” on
page 4-69.
12. Remove the top and side screws securing the left flatbed support.
13. Remove the left flatbed support.
14. Remove the top and side screws securing the right flatbed support.
15. Remove the right flatbed support.
16. Lift the tub assembly off of the MFP.
Note: After removing the tub assembly, remove the output binLED and LED cover. See “Output bin LED and
lens removal” on page 4-101. These will be used on the new tub assembly.
To Next Page
Loading...
