Lexmark X46X Series Service Manual

Diagnostics information 2-17
7014-xxx
39 Complex Page This message is displayed when a page is too complex to print.
The following actions can be taken:
•press
Select ( ) to clear the message and continue printing.
The job may not print correctly.
• Simplify the print job.
•press Menus ( ) to access the Busy/Waiting Menu.
The following functions may be available:
- Cancel Job
- Reset Printer
Note: Menu Lockout does NOT prevent access to the Busy/Waiting Menu.
50 PPDS Font Error This error only occurs when a printer is formatting PPDS print data.
The PPDS interpreter has detected a font error. When a specific font, which is not
installed, is requested based on a PPDS mode Set Font Global command, a
Select Code Page command, or a Comprehensive Font Selection command, and
the printer Best Fit setting is off. If Best Fit is on, the printer performs a best fit
search to find a similar font, and this error does not occur.
This error also displays when the printer receives invalid PPDS download font
data.
The following actions can be taken while this message is displayed:
•press Select ( ) to clear the message and continue printing.
The job may not print correctly.
•press Menus ( ) to access the Busy/Waiting Menu.
The following functions may be available:
- Cancel Job
51 Defective Flash
Detected
press
Select ( ) to clear the message and continue printing.
You must install different flash memory before you can download any resources to
flash.
52 Flash Full • press
Select ( ) to clear the message and continue printing.
• Delete fonts, macros, and other data stored on the flash memory.
• Install a larger capacity flash memory card.
53 Unformatted Flash press
Select ( ) to clear the message and continue printing.
You must format the flash memory before you can store any resources on it. If the
error message remains, the flash memory may be defective and require replacing.
54 Standard Network
Software Error
This message is displayed when the RIP software detects that a network port is
installed but cannot establish communications with it.
•press
Select ( ) to clear the message and continue printing.
The job may not print correctly.
• Program new firmware for the network interface.
• Turn the printer power off and then back on to reset the printer.
54 Network <x> Software
Error
The printer disables all communications to the associated network interface. No
data may be received or sent from or to the associated interface. The user can
program new firmware in the network using the parallel port after this message
clears.
•press
Select ( ) to clear the message and continue printing.
The job may not print correctly.
• Program new firmware for the network interface.
• Turn the printer power off and then back on to reset the printer.
55 Unsupported Option in
Slot <x>
An unsupported option is installed in the specified solutions port. Power off the
printer and remove the unsupported option in the specified slot.
Remove the unsupported option.
56 Parallel Port <x>
disabled
This error displays when data is sent to the printer across an optional parallel port,
but the port has been disabled. Once this message displays, reporting of further
errors is suppressed until the menus are entered, or the printer is reset.
User status and attendance messages (Continued)
User primary message Explanation

Lexmark X46X Series Specifications

General

Brand	Lexmark
Model	X46X Series
Category	Printer
Language	English