Lexmark X46X Series Service Manual

2-34 Service Manual
7014-xxx
888 Failure to transmit training successfully
at 2400 bps in V27 terminal modulation
scheme.
• Adjust “Transmit Level”.
• Check line quality.
889 Failed to connect at the minimum
speed supported by the MFP.
• Adjust “Transmit Level”.
• Incompatible connection.
88A Failed to connect using V.34
modulation scheme.
• Check line quality.
• Adjust to a lower modulation scheme.
• Adjust Transmit Level Receive
Threshold values.
901 No fax tones detected from remote
end.
• Verify destination phone number.
• Verify that the remote fax is authorized
to receive faxes.
902 No dial tone detected. • Check by enabling ‘Behind a PABX’
setting.
• Check phone line.
• Check MFD modem hardware.
903 Busy tone detected. Check with remote end if successive
attempts fail.
904 Hardware error detected. See “Modem / fax card service check”
on page 2-63.
905 A timeout occurred after dialing the
number and waiting for a response.
Check with remote end if successive
attempts fail.
906 Fax cancelled by user. No action needed.
907 Modem detected a digital line
connection.
Verify the MFP is connected to an analog
line. See
“Fax transmission service
check” on page 2-64.
908 Phone line was disconnected Restore phone line connection.
A00 Received request for unsupported
function from remote fax device.
No action needed.
A01 Received request for unsupported
image width from remote fax device.
No action needed.
A02 Received request for unsupported
image resolution from remote fax
device.
No action needed.
A03 Received request for unsupported
compression type from remote fax
device.
No action needed.
A04 Received request for unsupported
image length from remote fax device.
No action needed.
F00 Unknown error occurred. No action needed.
Fax error log codes (Continued)
Error code Description Action

Lexmark X46X Series Specifications

General

Brand	Lexmark
Model	X46X Series
Category	Printer
Language	English