2-64 Service Manual
7526
200.11, 250.03—Paper Jam error service check
Step Questions / actions Yes No
1 Open the front access door. Turn the
transport belt gear clockwise.
Did the transport belt move?
Go to step 2. Replace the transport belt.
See “Transfer module
removal” on page 4-191.
2
1. Disconnect the cable in connector
JFDPCK1, and connect the cables for the
new paper pick mechanisms.
2. Bring the printer up in Diagnostics Menu
(turn the multifunction printer off, press
and hold 3 and 6, turn the MFP on, and
then release the buttons when the
progress bar displays).
3. Touch MOTOR TESTS.
4. Touch Align Motor Test.
Can you hear the align motor run?
Go to “Input sensor
service check” on
page 2-147.
Replace the paper pick
mechanism. See “Paper
pick mechanism
assembly removal” on
page 4-137.
To Next Page
Loading...
